4.1.4.4 Volume of the swimming pool
Configure the volume of your swimming pool in m3, if the equipment is to work in semi-automatic mode.
The daily chlorination time will be calculated based on this parameter and the water temperature.
Whenever the value is changed, on exiting the menu the screen will display the minimum filtering time
the pump should work.
If at the end of the day, the filtering pump operates for less time than stipulated by the equipment for
an optimum level of chlorine in the water, the equipment will display a warning message.
4.1.4.5- Location of the swimming pool
Attention: This work mode only affects the semi-automatic operation mode.
The swimming pool may be installed outdoors or indoors. Function changes between INDOOR and
OUTDOOR when the OK key is pressed.
With this function, the equipment automatically reduces production to ½ if it is an indoor pool to avoid
excess chlorine.
4.1.4.6- Cover
The equipment may detect the presence of a cover on the swimming pool (only for automatic
covers). In this case, it is only necessary to place the limit switch of the cover in the terminal block, as
indicated in the section on electrical installation.
On placing the cover, the chlorinator automatically reduces production to 20%. This variation will be
reflected in the production %, and the letter "C" will be displayed on the right side of production in the
main screen. This will indicate that the cover is activated.
Once the cover detect ion is activated, the system will ask which is the type of sensor you have installed:
Normally open (N.O.) or Normally Closed (N.C.)
To Next Page
Loading...
