4.1.4.9- pH Alarm
The pH adjustment system will give an alarm and the dosing pump will stop operating when the pump
works continuously for more than 2 hours,
This could occur for the following reasons:
The acid tank is empty and therefore pH corrector is not being injected into the swimming pool.
The pH probe is dirty or worn, and cannot read the real value correctly.
However, what could occur, particularly when starting up the equipment for the first time, is that the real
pH of the water is a long way from the set value. The alarm can be disabled if it is calculated that the
pump needs to work continuously for several hours to correct the pH. However it is recommended to
enable the alarm once values near the set values are reached.
This alarm is activated from the factory
Note: Password “1234” is required to modify this function.
4.1.4.10 Chloride Alarm
When the unit is configured in automatic mode, it is possible to disable the “Chloride Alarm”. This alarm
will detect if the ORP or PPM reading hasn’t changed for two hours or more, despite the unit has been in
production.
Despite this alarm is been implemented to detect if a probe is not in good conditions, or there is some
chemical issue in the water, it can be disabled if the user wants to maintain the production despite
everything.
This alarm is disactivated from the factory
Note: Password “1234” is required to modify this function.
When an alarm occurs, the equipment stops its production, and displays an acoustic and light warning to
warn you of the need to resolve the incident.
However, it is possible to configure the acoustic warning through the following options:
- No: Acoustic warning always silenced.
- 24h: Acoustic warning activated 24 hours a day.
- Adjustable: Allows you to indicate within which time slot it will remain activated.
This alarm is disactivated from the factory
To Next Page
Loading...
