Battery performance
To keep the batteries in the best
condition, leave the handset off the
base for a few hours at a time.
Running the batteries right down at
least once a week will help them last as
long as possible.
After charging your handset for the
first time, subsequent charging time
for the batteries is approximately
6–8 hours.
The charge capacity of rechargeable
batteries will reduce with time as they
wear out, thus reducing the
talk/standby time. Eventually they
will need replacing. For details on how
to obtain spare batteries, call the
BT Graphite 1500 Helpline on
0870 242 6652*.
ii. Insert the 2 x AAA rechargeable batteries supplied, taking
note of the polarity markings inside the battery compartment,
then slide the battery compartment shut.
The display will show the handset number,
2
, to show it is
registered to the base.
iii. Place the handset on the charger. It will beep when placed in
and the battery icon on the handset will flash to indicate
charging. You should let the batteries charge continuously for
at least 24 hours.
Any additional handsets supplied as part of a multipack are
pre-registered to the base. So, once charged, are ready for use.
Connect to the telephone line
4. Plug the telephone line cord into the socket marked on the
back of the base and plug the other end into the telephone
wall socket.
8 Getting started
If you experience any problems, please call the Helpline on 0870 242 6652*
IMPORTANT
Only use the telephone line cord
supplied with the phone.
To Next Page
Loading...
Need help?
General
