Introduction Maintenance – P1
Safety regulations with maintenance work
Order number Date Valid from serial number T-code
226057-040 2005-09-23 914369- 675
© BT Europe AB Service Manual LWE130 2- 1
2- Introduction Maintenance – P1
All points in the service program should be carried out to attain the high-
est safety and the least possible downtime. The service intervals are
only a guide and do not need to be followed to the letter. The operator
may adapt them to local conditions, but it is important that the intervals
comply with BT’s minimum requirements.
The service intervals are based on the running times and can be adapt-
ed to most normal 8 hour shifts. The service interval may be shortened
if the truck is used more frequently or in more demanding situations, e.g
cold store, dusty or corrosive situations. The following running times
have been used when calculating the intervals:
- Day time: 08.00-17.00 (20 hr./week)
- 2-shifts: 06.00-14.00, 14.00-22.00 (40 hr./week)
- 3-shifts: 06.00-14.00, 14.00-22.00,22.00-06.00
(60 hr./week)
Ensure the truck is given a regular maintenance service after every 500
driving hours. The truck’s safety, efficiency and service life is depend
-
ent on the service and maintenance it is given.
Only use BT approved spare parts when service and repair work are
carried out.
2.1 Safety regulations with
maintenance work
Only personnel that have been trained in the service and repair of this
type of truck are authorised to carry out service and repair work.
• Do not carry out any maintenance work on the truck unless you have
the correct training and knowledge to do so.
• Keep the area where you carry out the service clean. Oil or water
makes the floor slippery.
• Never wear loose objects or jewellery when working on the truck.
WARNING!
Short-circuiting/Burns.
When working with the truck’s electrical system, short-circuiting/
burns can occur if a metal object comes into contact with live electri
-
cal connections.
Remove watches, rings or other types of metal jewellery.
• Always disconnect the battery by pulling out the battery isolator
when carrying out maintenance work on the truck unless otherwise
stated in this Service Manual.
• Always switch off the truck’s power supply before opening the cov-
ers on the drive unit or electrical system.
• Relieve the system pressure slowly before starting work on the
truck’s hydraulic system.
https://www.besttruckmanuals.com/
To Next Page
Loading...
