BT LWE130 - From the Hand Terminal to the Truck; Calibrating the Speed Potentiometer; General

12- 42 Service Manual LWE130 © BT Europe AB
Electrical system – 5000
Parameters & adjustments
T-code Valid from serial number Date Order number
675 914369- 2005-09-23 226057-040
From the hand terminal to the truck
To transfer a parameter set from the hand terminal to the truck use the
RESTOR PARAMETER function in the hand terminal:
• Connect hand terminal. See “Connecting the hand terminal” on
page 27.
• Select RESTOR PARAM from the menu and press ENTER.
• Press ROLL to select the relevant memory slot (Mod 00 to Mod 31).
• Press ENTER. The parameter set will be restored to the transistor
regulator’s memory.
12.10.6 Calibrating the speed potentiometer
General
The transistor regulator [A1] can be calibrated to allow the speed
potentiometer [R1] to give a smooth and symmetrical response over
the whole operating range. Perform a calibration in the following cir
-
cumstances:
*MAIN MENU*
PARAMETER CHANGE
* MAIN MENU *
STEER TABLE
*MAIN MENU*
PROGRAM VACC
*MAIN MENU*
ALARMS
*MAIN MENU*
RESTOR PARAM.
ENTER
ROLL
SELECT Mod 00
SELECT Mod 01
SELECT Mod 02
SELECT Mod 31
OUT
SEM-X V
NO DATA FOR THIS
CHOPPER! (OUT)
ARE YOU SURE ?
YES = ENTER NO = OUT
STORING
Run all parameters
ENTER
ENTER
SEM-X V..
24v 75A 00000
ENTER
ROLL
https://www.besttruckmanuals.com/