BT LWE130 - Hand Terminal Menus

Electrical system – 5000
Functional description
Order number Date Valid from serial number T-code
226057-040 2005-09-23 914369- 675
© BT Europe AB Service Manual LWE130 12- 29
Hand terminal menus
To enter one of the main menu modes:
• Press ENTER from the initial display and then...
• Repeatedly press ROLL until the relevant menu is shown then...
•Press ENTER.
See following sections for detailed information regarding each menu
function.
SEM-X V..
24v 75A 00000
*MAIN MENU*
PARAMETER CHANGE
* MAIN MENU *
STEER TABLE
* MAIN MENU *
PROGRAM VACC
* MAIN MENU *
ALARMS
* MAIN MENU *
RESTOR PARAM.
* MAIN MENU *
SAVE PARAM.
* MAIN MENU *
TESTER
ENTER
ROLL
ROLL
ROLL
ROLL
ROLL
ROLL
ROLL
OUT
Normal hand terminal display
Menu for changing or setting parameters
This is menu is not applicable
Menu for calibration of speed control potentiometer [R1]
Menu for displaying error history
Menu for downloading a parameter set-up from the hand terminal
to the transistor controller
Menu for uploading a parameter set-up from the transistor con-
troller to the hand terminal
Menu for diagnostic functions
https://www.besttruckmanuals.com/