BT LWE130 - Parameters & Adjustments; General; Adjusting Parameters

Electrical system – 5000
Parameters & adjustments
Order number Date Valid from serial number T-code
226057-040 2005-09-23 914369- 675
© BT Europe AB Service Manual LWE130 12- 37
12.10 Parameters & adjustments
12.10.1 General
The truck’s control system stores a number of parameters. These
parameters are used to configure the truck for correct operation in the
particular application for which it was designed. The parameters are
adjusted using the hand terminal.
12.10.2 Adjusting parameters
To adjust a parameter use the PARAMETER CHANGE function in the
hand terminal:
• Connect hand terminal. See “Connecting the hand terminal” on
page 27.
• Select PARAMETER CHANGE from the menu and press ENTER.
• Press ROLL buttons to display the required parameter.
• Adjust the setting of the parameter with the PARAM SET buttons.
• Press OUT followed by ENTER to store the new parameter setting
or.
• Press OUT followed by OUT to return to the main menu without
changing the existing parameter setting.
NOTE!
Truck handling.
Modifying specific truck parameters will change the driving charac-
teristics of the truck.
Do not change any parameters without the necessary know how.
SEM-X V..
24v 75A 00000
* MAIN MENU *
PARAMETER CHANGE
ENTER
ENTER
ROLL
A
CC.DELAY 0-9
RELEASE BRAKING 0-9
INVERSION BRAKING 0-9
CHECK UP DONE
OFF
CHECK UP TYPE 0-3
CHECK UP HOURS 0-9
ARE YOU SURE ?
YES=ENTER NO= OUT
VALUE CHANGED
VALUE NOT CHANGE VALUE NOT CHANGED
ROLL = CHOOSE PARAMETER
PARAM SET = CHANGE VALU
E
OUT
DECELER DELAY 0-9
CUTBACK SPEED 3 0-9
https://www.besttruckmanuals.com/