General safety rules
Safety while working
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 3 – 1
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
3 – General safety rules
Only persons trained in servicing and repairing this type of truck are
qualified to carry out servicing and repair work.
3.1 Safety while working
To ensure that you work safely and to prevent accidents while working
on a truck, remember the following:
• keep the area where servicing activities are performed clean. Oil or
water will make the floor slippery.
• use the correct working position. Service activities often involve
kneeling or bending forward. Try sitting on a toolbox, for example, to
relieve the strain on your knees and back.
• loose articles and jewellery may become trapped in the moving parts
of the truck. Never wear loose articles or jewellery while working on
the truck.
• use well maintained tools that are intended for the work being
carried out.
• store and transport old oil according to applicable local regulations.
• do not flush solvents or similar that have been used for cleaning
down drains that are not intended for this purpose. Follow the local
disposal regulations.
• heated paint gives off harmful gases. Therefore remove the paint at
least 100
mm around the welding/grinding area using sanding
equipment or paint remover when welding or grinding a painted
area.
https://www.besttruckmanuals.com/
To Next Page
Loading...
