4 – 4 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Installation
Programming PIN codes
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
Programming the PIN codes is now finished. Verify that the
programming is correct by logging in with some of the new PIN
codes.
Note!
It is important to establish that the correct driver profile is activated
when a certain PIN code is stated. This especially applies when a
driver profile is set up for a specific application.
4.3.1 Standards for PIN codes
The table below shows the PIN codes that are found as standard in the
programme. The PIN codes can be activated or changed according to
the driver's wishes. A driver profile is activated with the normal log in of
all PIN codes, whose block number is activated.
The truck programme does not permit a login using the PIN code 0000.
Note!
It is recommended that service personnel keep notes about activated
blocks, changed PIN codes and specially adjusted driver profiles.
Standard assignment for PIN codes
Drive
r
profil
e
no.
1 2 3 4 5 6 7 8 9 10
Note!
Stated
as 0
Block 0 0001 0002 0003 0000 0000 0000 0000 0000 0000 0000
Block 1 7901 1437 3731 1049 9439 7265 1322 2869 1574 5421
Block 2 4854 2907 9175 5799 1490 3031 7392 5622 5023 1787
Block 3 3174 1026 3815 6703 1179 5152 7514 5668 3215 4659
Block 4 7110 5477 3846 9491 5918 8222 6923 8139 7025 9197
Block 5 6276 9879 9658 1690 4042 5201 9807 4332 9715 2549
Block 6 4142 8620 3754 8432 8788 7430 1948 2595 8527 7474
Block 7 1482 7135 2395 7365 7092 4611 2831 4185 6067 1930
Block 8 4731 1022 5377 3257 7334 9009 7881 8843 7436 2876
Block 9 3162 5878 2828 1910 6907 2136 5730 2957 7691 3242
https://www.besttruckmanuals.com/
To Next Page
Loading...
