Accessories
Built-in battery charger
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 19 – 3
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
19.5 Built-in battery charger
Note:
When installing a battery charger as an aftermarket procedure,
TruckCom is needed in order to set all parameters. TruckCom is not
needed when replacing an existing battery charger. Tighten the
battery charger mounting nuts (A) with a maximum of 1.6 Nm.
The battery charger is set for the battery if the truck is delivered from
the factory with a battery installed.
If the truck is delivered without a battery, the client or a technician must
set the correct parameter according to type and size of the battery.
19.5.1 Technical data
Designation SMCO 24/30
Dimensions, mm 240x111x77
Weight, kg 1.7
Ambient temperature, ºC -25 - +40 (freely vented batteries)
+15 - +30 (valve regulated batteries)
Supply voltage, V AC 195-264
Rated voltage, V DC 24
Rated current, A 30
Maximum output, W 800
B
https://www.besttruckmanuals.com/
To Next Page
Loading...
