17 – 10 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Hydraulic system 6000
Adjustment of the pressure limit valve
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
4. Screw in the adjustment screw clockwise until the truck is able to lift
the load without problems.
5. Tighten the lock nut (c) clockwise.
6. Refit the washer and protective cover (b).
7. Push a new sealing cap (a) around the pressure limiting valve
Once the truck is able to lift the rated load, add a further 100 kg onto
the forks. Verify that the truck cannot lift the load.
If the truck is able to lift 100 kg more than its rated load:
1. Prise off the sealing cap (a) around the pressure limiting valve
using a screwdriver.
2. Loosen the protective cover (b) (17 mm) by turning it anti-
clockwise. Remove the protective cover and washer inside it.
3. Loosen the lock nut (c) (17 mm) by turning it anti-clockwise.
4. Unscrew the adjusting screw anti-clockwise until the truck cannot
lift the load.
5. Tighten the lock nut (c) clockwise.
6. Refit the washer and protective cover (b).
7. Push a new sealing cap (a) around the pressure limiting valve
https://www.besttruckmanuals.com/
To Next Page
Loading...
