4 – 8 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Installation
Setting the parameters
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
Note!
If factory parameter 1101 has been set to 0 (zero), service parameters
109 and 110 should also be set to 0 (zero). If the truck has software
version -006 or later, and if the factory parameter 1101 has the value 0
(zero), service parameter 109 must have the value 0 (zero) and 110
must have the value 100 (one hundred). The values of service
parameters 109 and 110 only need to be changed if the truck is
equipped with a built-in charger and the value of factory parameter
1101 has been set to 1.
Parameter Name/unit Min/
Max
Incr
eme
nt
Std Description
107 service
parameter
Battery
adjustment, Ah
1/20 1 9 9 = Large battery
13 = Medium battery
17 = Small battery
For more information, see text following
the table.
See section“4.4.3 Parameter
107 - battery size”.
109 service
parameter
Battery
charger,
battery type
0/3 1 0 State battery type
0 = No charge. Standard type. Error
code is displayed if this parameter is
set at 0 when there is a battery charger
and factory parameter 1101 is set at 1.
1 = Lead/acid battery
2 = Hawker Evolution battery. Sizes
134 Ah, 174 Ah, 201 Ah
3 = Exide GEL battery
110 service
parameter
Built-in battery
charger,
battery
capacity, Ah
0/300
(100/
300)
1 0
(100)
State battery capacity.
0 (100) = No charge. Standard type.
Error code is displayed if this
parameter is set at 0
(100) when there
is a battery charger and factory
parameter 1101 is set at 1.
The values in brackets () apply if the
truck has software version -006 or later.
1101 factory
parameter
Built-in battery
charger
0/1 1 0 0 = No battery charger
1= Battery charger present
https://www.besttruckmanuals.com/
To Next Page
Loading...
