Need help?Do you have a question about the BTEK DD 700 and is the answer not in the manual?
Accessing the calibration switch on plastic and stainless steel terminals with connectors.
Accessing the calibration switch on stainless steel terminals with cable glands.
Covers scale sampling methods like full scale zero, linearised, and hysteresis correction.
Covers angle calibration, testing, saving, and restoring terminal data for digital scales.
Instructions for removing the support bracket, specifically for stainless steel versions.
Procedures for opening ABS and stainless steel terminals, including connector disconnection.
Steps to disconnect and remove the display from ABS and stainless steel versions.
Procedure for removing the power supply from stainless steel versions with cable glands.
Steps for removing and replacing the lithium battery across different terminal versions.
Procedures for removing first (welded) and second analogue scales for various versions.
Steps to remove the digital scale from ABS and stainless steel terminal versions.
Procedures for removing the I/O board from ABS and stainless steel terminal versions.
Steps to remove the motherboard from plastic and stainless steel terminal versions.
Follow instructions supplied with the optional boards for installation.
Follow instructions for serial port and USB peripheral connections.
Accessing the calibration switch on plastic and stainless steel terminals with connectors.
Accessing the calibration switch on stainless steel terminals with cable glands.
Covers scale sampling methods like full scale zero, linearised, and hysteresis correction.
Covers angle calibration, testing, saving, and restoring terminal data for digital scales.
Instructions for removing the support bracket, specifically for stainless steel versions.
Procedures for opening ABS and stainless steel terminals, including connector disconnection.
Steps to disconnect and remove the display from ABS and stainless steel versions.
Procedure for removing the power supply from stainless steel versions with cable glands.
Steps for removing and replacing the lithium battery across different terminal versions.
Procedures for removing first (welded) and second analogue scales for various versions.
Steps to remove the digital scale from ABS and stainless steel terminal versions.
Procedures for removing the I/O board from ABS and stainless steel terminal versions.
Steps to remove the motherboard from plastic and stainless steel terminal versions.
Follow instructions supplied with the optional boards for installation.
Follow instructions for serial port and USB peripheral connections.
To Next Page
General