BTEK DD 700 - Stainless Steel Version with Cable Glands

27
INSTALLATION MANUAL DD700
2.9.3 Stainless steel version with cable glands
Figure 2.9-3 – Disassembling I/O board
Referring to the previous figure, proceed as follows:

Open the terminal.

Disconnect the digital scale from the terminal.

Disconnect the connector (ref. 1) from its equivalent on the motherboard.

Unscrew the screws (ref. 2) and remove the I/O board (ref. 3).

Disconnect the connector (ref. 4) from the I/O board.
4
1
3
2