EasyManuals Logo

Buderus Logamatic 4323 User Manual

Buderus Logamatic 4323
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Standard functions
6
Logamatic 4323 - Subject to technical modifications.
18
Subject to the way your installer has configured your system, it may be that one
or more MEC2 displays will not appear, although the above modules are fitted
in your control unit.
Detailed descriptions of MEC2 displays for other modules are included in the
corresponding module documentation.
6.2 Permanent display
There are two different permanent displays. One of the factory-set permanent
displays is shown, subject to whether the MEC2 is fitted in a control unit or is
installed as a wall mounted unit.
Factory-set permanent display, if the MEC2 is fitted in the control unit.
Factory-set permanent display, if the MEC2 is installed as a wall mounted unit.
USER NOTE
If your heating system is equipped with several heating circuits, you must first
select the correct heating circuit (Æ Chapter
7.6). Only then can you select the
operating mode and the room temperature.
USER NOTE
The following MEC2 displays only describe the possible displays:
of module ZM433 (standard equipment level).
of the most frequently used FM441 and FM442 modules (auxiliary
equipment).
Common flow
Outside temp.
21°C
45°C
Actual room
Outside temp.
0°C
19.5°C

Table of Contents

Other manuals for Buderus Logamatic 4323

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Buderus Logamatic 4323 and is the answer not in the manual?

Buderus Logamatic 4323 Specifications

General IconGeneral
BrandBuderus
ModelLogamatic 4323
CategoryControl Unit
LanguageEnglish

Related product manuals