Buderus Logamatic 4323 User Manual

Standard functions
6
Logamatic 4323 - Subject to technical modifications.
22
6.4 Setting the room temperature
With the flap closed you can adjust the room temperature with the rotary
selector. With the flap open, you can also press "Day mode" or "Night mode".
With the rotary selector, you may select the room temperature in degree steps
between 11
°C (day), or 2 °C (night) and 30 °C. The set temperature is displayed
via an LED next to the rotary selector. For temperatures below 15
°C or above
25
°C, the "–" or "+" LED illuminates.
The factory setting for the day room temperature is 21 °C.
The factory setting for the night room temperature is 17 °C.
Any adjustment applies to all heating circuits allocated to the MEC2
programming unit (Æ Chapter
7.7).
6.4.1 For the current operating mode
You are currently in automatic "Day mode" and would like to alter the room
temperature.
(Condition: For this, the programming unit flap must be closed.)
Turn the rotary selector to the required day room temperature (here: "23°C").
The day room temperature is now adjusted to 23 °C. The selected permanent
display will then appear again.
Tag Zeit Temp
Urlaub Auswahl So/Wi
Anzeige Heizkreis Zurück
AUT
AUT
USER NOTE
The set room temperature applies to the currently active heating mode, i.e. day
or night mode. You will recognise whether the currently active heating mode is
on because the green LED will be illuminated.
Set room
Automatic day
23°C

Buderus Logamatic 4323 Specifications

General

Brand	Buderus
Model	Logamatic 4323
Category	Control Unit
Language	English