Buderus Logamatic 4323 User Manual

Extended functions
7
Logamatic 4323 - Subject to technical modifications.
37
7.10 Selecting a standard program
The MEC2 programming unit is equipped with eight different, preset heating
programs that act as standard programs. See the following page for a summary
of the preset times of the standard programs.
Please check which standard program best meets your requirements.
First
check the number of switching points and then the relevant times.
The
"Family" program is preset at the factory.
z Open flap.
z Select a heating circuit (Æ Chapter 7.6).
Hold down "PROG". First, the heating circuit for which you want to select
a
standard program is displayed. Approximately two seconds later the
designation of the
currently selected standard program will appear.
Select the required standard program with the rotary selector (here: "Seniors").
Release the "PROG" key. The displayed program is now selected.
The display shows the program designation and the first switching point for
the
selected heating program (here: "Senior program").
Press "Back" to return to the permanent display.
AUT
+
Time switch
Program select.
Seniors
Senior program
Monday
21°C
at 05:30
USER NOTE
Switching programs are only effective in automatic mode (Æ Chapter 6.3.1).

Buderus Logamatic 4323 Specifications

General

Brand	Buderus
Model	Logamatic 4323
Category	Control Unit
Language	English