Additional programming options
8
Logamatic 4323 - Subject to technical modifications.
63
8.3 Creating a new DHW program
You may operate DHW heating either according to the factory settings "Program
select. by heat. circs" or according to your own new switching program "Program
select. own DHW".
If your DHW is to be heated independently of the heating circuits, you can enter
your own new DHW program as follows:
Example:
On all weekdays DHW should be heated from 06:30 until 09:00.
z Select a heating circuit (Æ Chapter 7.6).
(here: "DHW")
z Select a program for the heating circuit "DHW" (Æ Chapter 7.10).
(here: "Program select. new")
The display shows a blank screen "New switch.point" for the new switching point.
z Enter the switching points (Æ Chapter 8.2).
DHW heating will now operate according to your "Own program DHW". You can
call up your new "Own program DHW" by pressing "Prog" and turning the rotary
selector (Æ
Chapter 7.6).
USER NOTE
With the factory setting "Program select. by heat. circs", DHW is heated
30
minutes prior to the first switching point of all heating circuits associated
with this control unit, and ends when the last heating circuit is switched off.
USER NOTE
Only after all three details (day/time/temperature) have been defined the new
switching point will be automatically saved under "Own program DHW" and the
heating circuit selection "DHW". The saving function is not visualised on the
display. The display shows a blank screen "New switch.point" for the next
switching point. Repeat this process for all required switching points.
To Next Page
Loading...
Need help?
General
