Buderus Logamatic 4323 User Manual

Extended functions
7
Logamatic 4323 - Subject to technical modifications.
43
7.14 Setting the DHW operating mode
This allows you to change the DHW temperature in the DHW cylinder.
z Open flap.
Hold down "Heating circ." and select "DHW" with the rotary selector.
Release the "Heating circuit" key.
The permanent display will then appear again.
Select one of the following operating modes for DHW:
– "Constant operat."
The water inside the DHW cylinder is constantly maintained at the set
temperature.
Press "Day mode" to select constant operation. After approx. three seconds,
the
permanent display will appear again.
– "Automatic"
30 minutes before the first heating circuit is switched on, the boiler will heat
the DHW cylinder to the set temperature, and stop when the last heating
circuit is switched off (factory setting). Alternatively, you can enter your own
individual DHW program (Æ
Chapter 8.3).
Press "Automatic" to select automatic mode. After approx. three seconds,
the
permanent display will appear again.
– "DHW OFF"
DHW heating is switched off. Pressing "DHW" switches heating on for the
duration of DHW heating once.
Press "Night mode" to stop DHW heating. After approx. three seconds,
the
permanent display will appear again.
AUT
AUT
+
Heat. circ. sel.
DHW
Actual room
Outside temp.
0°C
19.5°C
AUT

Buderus Logamatic 4323 Specifications

General

Brand	Buderus
Model	Logamatic 4323
Category	Control Unit
Language	English