Entering Programming
Mode
To program features, your vehicle must be
in
the
programming mode. Follow these steps:
1.
Turn the ignition key to ON with the vehicle in
2.
Press and release the MODE button, scrolling
PARK
(P).
through the DIC messages, until
PERSONALIZATION PRESS SET
TO
BEGIN is
displayed.
3.
Press the SET button and
TO
SELECT DRIVER
PRESS REMOTE
LOCK
will appear. Press the
LOCK
button on the remote keyless entry.
This identifies which remote keyless entry
transmitter is being programmed by displaying
PERSONALIZATION FOR DRIVER
1
or DRIVER
2.
PROGRAM
MODE
1
I
United States
Canada
4.
The program mode message will appear in the
message center as an indication that your vehicle
is
ready to begin programming.
5.
Follow the instructions given by the DIC.
Headlamp
Exit
Delay
This feature allows you to customize the headlamps and
parking lamps. This feature can be programmed
to
one of the following modes:
OFF:
The headlamps and parking lamps
will
not turn
on at the same instant that the ignition is turned to OFF.
15:
The headlamps and parking lamps
will
stay on
for
15
seconds when the ignition is turned to OFF.
30:
The headlamps and parking lamps will stay on
for
30
seconds when the ignition is turned
to
OFF.
60:
The headlamps and parking lamps
will
stay on for
60
seconds when the ignition is turned to OFF.
3-60
To Next Page
Loading...
