EasyManua.ls Logo

Buick 2003 Rendezvous - Page 212

Buick 2003 Rendezvous
468 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before your vehicle was shipped from the factory, it was
programmed in
30
second activation mode. The
mode to which the vehicle has been programmed may
have been changed since
it
left the factory. To
determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1.
Follow the instructions for “Entering Programming
2.
Press the MODE button until HEADLAMP EXIT
Mode” listed previously.
DELAY appears in the DIC.
3.
Press the SET button until the arrow is before the
mode you prefer.
The mode you selected
is
now set. You can either exit
programming mode by following the instructions later
in
this section or program the next feature available on your
vehicle.
Interior
Lighting
Delay
The interior liqhting delay feature can be programmed to
one of the following modes:
OFF:
This feature will not illuminate the interior of your
vehicle when all of the doors are closed.
ON:
This feature will continue to illuminate the interior
iamps
for
25
seconds
after
all
doors have been
closed so that you can find your ignition and buckle
your safety belt at night.
Interior lighting delay will not occur while the ignition is
in
ON.
After
25
seconds, the interior lamps will fade
out. The lamps will fade out before the
25
seconds
if:
The ignition is turned to
ON,
0
all doors are locked using the remote keyless entry
there is no occupant activity detected for an
transmitter, or
illumination period of
25
seconds.
Before your vehicle was shipped from the factory, it was
programmed
in
ON. The mode to which the vehicle
has been programmed may have been changed since it
left the factory. To determine the mode to which your
vehicle is programmed or to program your vehicle
to a different mode, do the following:
1.
Follow the instructions for “Entering Programming
2.
Press the MODE button until INTERIOR LIGHTING
3.
Press the SET button until the arrow is before
ON
Mode” listed previously.
DELAY appears on the DIC.
or
OFF-.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
3-6
1

Table of Contents

Related product manuals