ALL:
All doors will unlock with every press of UNLOCK
on the remote keyless entry transmitter.
Before your vehicle was shipped from the factory,
it
was
programmed in ALL. The mode to which the vehicle
has been programmed may have been changed since
it
left the factory. To determine the mode to which your
vehicle is programmed or to program your vehicle
to a different mode, do the following:
1.
Follow the instructions for “Entering Programming
2.
Press the MODE button until REMOTE DOOR
3.
Press the SET button until the arrow is before
Mode” listed previously.
UNLOCK appears on the DIC.
DRlVERiALL
or
ALL.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later
in
this section or program the next feature available
on your vehicle.
Unlock
Feedback
The unlock feedback feature can be programmed to one
of the following modes:
LIGHTS: This mode does the following:
e
e
During the day, when the ignition is in OFF and
UNLOCK on the remote keyless entry transmitter
is pressed, the headlamps and parking lamps
will flash, or
During the night, when the ignition is
in
OFF, the
headlamps and parking lamps will be activated
for
30
seconds when UNLOCK is pressed on the
remote keyless entry transmitter. If you would like to
change the headlamp exit delay feature.
chn-
I
la1
Ige
the
amwnt
e?
time
the
!amps
stay
QE,
OFF:
The headlamps and parking lamps will not flash
when UNLOCK is pressed on the remote keyless
entry transmitter.
3-65
To Next Page
Loading...
