Before your vehicle was shipped from the factory, it was
programmed in LIGHTS. The mode to which the
vehicle has been programmed may have been changed
since it left the factory. To determine the mode to
which your vehicle is programmed or to program your
vehicle to a different mode, do the following:
1.
2.
3.
4.
5.
Follow the instructions for “Entering Programming
Mode” listed previously.
Follow the instructions for programming HEADLAMP
EXIT DELAY earlier in this section, to make sure
which mode
it
is programmed to.
Press the SET button until UNLOCK FEEDBACK
appears on the DIC.
Press the MODE button until the arrow
is
before
LIGHTS or OFF.
Press the SET button once you have determined
which mode
you
prefer.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Lock
Feedback
The lock feedback feature can be programmed to one
of the following modes:
OFF:
When LOCK is pressed on the remote keyless
entry transmitter, the headlamps and parking lamps will
not flash and the horn will not sound.
LIGHTS:
When LOCK is pressed on the remote
keyless entry transmitter, the headlamps and parking
lamps will flash briefly.
LIGHTS
and
HORN:
When LOCK is pressed a second
time on the remote keyless entry transmitter within
five seconds, the headlamps and parking lamps
will flash briefly and the horn will sound.
Before your vehicle was shipped from the factory,
it
was
programmed in LIGHTS and HORN. The mode to
which the vehicle has been programmed may have been
changed since it left the factory. To determine the
mode to which your vehicle is programmed or to
program your vehicle to a different mode, do the
following:
3-66
To Next Page
Loading...
