1.
Follow the instructions for ”Entering Programming
Mode” listed previously.
3.
Press the SET button until the arrow is before ON
or OFF.
2.
Press the MODE button until LOCK FEEDBACK If the seat recall feature has been programmed to ON,
appears on the DIC. the seat recall feature can also be programmed to
3.
Press the SET button until the arrow is before OFF, one of the modes:
LIGHTS or LIGHTS and HORN.
MEMORY: The position recalled will be the memory
The mode you selected is now set. You can either exit driving position.
Seat Recal
I
The seat recall feature can be programmed to one of
the following modes:
ON: The previously programmed memory seat position
will be recalled when the UNLOCK button is pressed
on the remote keyless entry transmitter.
OFF:
No
memory seat position will be recalled when
you press the UNLOCK button on the remote keyless
22:try
tE??S%?l?tPr-.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1.
Follow the instructions for “Entering Programming
2. Press the MODE button until SEAT RECALL
Mode” listed previously.
appears on the DIC.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
I.
FO!!OW
the
instrcrctions
for “Entering Programming
2.
Follow the instructions for programming SEAT
3.
Press the MODE button until RECALL POSITION
Mode” listed previously.
RECALL to ON listed previously.
appears on the DIC.
MEMORY or EXIT.
4.
TlebS
LIIe
3c
I
UULLUII
UIILII
LIIG
aiiuvv
IJ
UCIIUI~
1
n..-
__
&I--
~I-T
I-..*&--
.,-+:I
+L~
_wr_..,
;e
hnfnrr\
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
3-67
To Next Page
Loading...
