Tilt
Mirror
The
tilt
mirror feature can be programmed to one of the
following modes:
ON:
The passengers side outside rearview mirror will
tilt down towards the curb when the vehicle is shifted to
REVERSE
(R)
and returns to its previous position
when the vehicle is shifted out of REVERSE
(R).
OFF:
The mirror will not tilt.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1.
Follow the instructions for “Entering Programming
2.
Press the MODE button until TILT appears on
Mode” listed previously.
the DIC.
3.
Press the SET button until the arrow is before ON
The mode you selected
is
now set. You can either exit
programming mode by following the instructions
later
in
this section or program the next feature available
on your vehicle.
or
OFF.
Exiting Programming Mode
To
exit programming mode, do one of the following:
Shift out
of
PARK (P),
turn the ignition key out of ON, or
do not program any commands for one minute
while in the programming mode.
The programming mode message will turn off
to
let you
know that you are no 1onge.r in the programming mode.
Once you have reached the end of the personalization
features, PERSONALIZATION SELECTION DONE
will appear briefly. Then PRESS SET TO EXIT MODE
TO
CONTINUE will appear. Pressing SET
will
exit
you out of the
DIC.
Pressing MODE will take you to the
beginning of personalization.
3-68
To Next Page
Loading...
