Adjusting
the Speakers (Balance/Fade)
AUDIO:
To
adjust the balance between the right
and the left speakers, push and release AUDIO until
BAL appears on the display. Then turn the AUDIO knob
to
move the sound toward the right or the left speakers.
A bar graph with indicators will show how the sound
is balanced between the right and the left speakers.
To
adjust the fade between the front and the rear
speakers, push and release AUDIO until FADE appears
on the display. Then turn the AUDIO knob
to
move
the sound toward the front or the rear speakers.
A
bar
graph with indicators will show how the sound is
balanced between the front and rear speakers.
To
adjust balance or fade to the middle position, select
BAL or FADE. Then push and hold AUDIO for more
than two seconds until you hear a beep. The indicator
will be centered on the display.
To
adjust both tone controls and both speaker controls
to
the middle position, end out of audio mode by
pushing the AUDIO knob until the display goes blank.
Then press and hold AUDIO for more than two seconds
until you hear a beep. ALL CENTERED will appear
on the display.
Using
RDS
Your audio system is equipped with a Radio Data
System (RDS). RDS features are available for use only
on FM stations that broadcast RDS information.
Using this system, the radio can do the following:
Seek
to
stations broadcasting the selected type of
receive announcements concerning local and
programming,
national emergencies,
display messages from radio stations, and
seek
to
stations with traffic announcements.
This system relies upon receiving specific information
from these stations and will only work when the
information is available. In rare cases, a radio station
may broadcast incorrect information that
will
cause
the radio features
to
work improperly.
If
this happens,
contact the radio station.
While you are tuned
to
an RDS station, the station
name or the call letters will appear on the display,
instead of the frequency. RDS stations may also provide
the time of day,
a
program type
(PTY)
for current
programming and the name of the program being
broadcast.
EQ
(Equalizer): Press this button
to
choose bass, mid
and treble equalization settings designed for different
program types.
3-72
To Next Page
Loading...
Need help?
General
