4.
5.
6.
8.
Attach the folding wrench to the hoist shaft.
Turn the folding wrench clockwise to lift the
spare tire.
When the tire reaches the stabilizer bar, move the
tire over the bar, then continue
to
turn the folding
wrench clockwise to lift the spare tire.
When the tire is almost in the stored position, turn
the tire
so
that the valve stem is towards the rear of
the vehicle.
This will help when you check and maintain tire
pressure in the spare.
Raise the tire fully against the underside of the
vehicle. Continue turning the folding wrench until
you feel more than two clicks. This indicates that the
compact spare tire is secure and the cable is
tight. The spare tire hoist cannot be overtightened.
PUSH
&
PULL
9.
Make sure the tire is stored securely. Push, pull,
and then try to rotate or turn the tire.
If
the tire
moves, use the folding wrench to tighten the cable.
5-80
To Next Page
Loading...
