1.
Flip up the D-ring located in the rear cargo area.
2.
Lay the tire in the rear cargo area of the vehicle with
the valve stem up with the center hole of the tire
over the D-ring.
For vehicles with aluminum wheels, remove the
center cap by tapping the back
of
the cap with the
folding wrench.
3.
Remove the J-hook and the wing nut from the back
of the jack access door. Assemble the wing nut and
the J-hook.
4.
Install the wing nut and the J-hook to the D-ring
through the center hole
of the tire.
5.
Tighten the wing nut to secure the tire to the floor.
Push and pull on the tire
to
make sure the tire is
secure and does not move.
6.
Put back all
tools
as they were stored in the jack
storage compartment and put the compartment
cover back on.
Slip the tabs on the side of the compartment cover
into the cover opening. Push the cover in place
and push down the tabs on the cover
so
that it rests
in the groove. This secures the cover in place.
Storing the Flat Tire (Vehicles with the
Rear Convenience Center)
A. D-Ring
B.
Rear Convenience
Center
C. Wing Nut
D.
J-Hook
E.
Full-Size Tire
F.
Cap on Bottom of
Storage Compartment
5-82
To Next Page
Loading...
Need help?
General
