18
EVENTS
The Events page displays the ARC Plus SL event list.
Use the Show more or Show all links at the bottom of the page to display more events. When all events are
displayed, “All events shown” will appear at the bottom of the page.
SYSTEM
The System page allows you to perform several system related actions, described below:
NETWORKING
Use the Networking page to set the networking parameters on the ARC Plus SL. Use the onscreen help text
for more information.
REBOOTING
The Reboot link will reboot the ARC Plus SL. You will see a confirmation prompt before the system reboots.
RESETTING TO FACTORY DEFAULTS
The Reset to Factory Defaults link on the web page will reset the ARC Plus SL to its factory default settings
except for your network settings and authorization codes. The page will show a confirmation.
Resetting to the Factory Default including the network settings can be done as follows:
1. Unplug the unit
2. Press and hold the front panel switch
3. Plug in the unit while holding in the switch
4. Wait for the FAULT LED to stop flashing.
5. Unplug the unit
6. Plug in the unit
Network settings will be returned to the factory
default, including the IP address, which is reset to
192.168.0.100.
Warning:
Resetting the ARC Plus SL to factory
defaults will erase all of your
configuration and data from the unit. It is
strongly recommended that you create a
back-up in AutoLoad Plus.
This operation cannot be undone.
To Next Page
Loading...