7.8 System
7.8.1 Time Allows setting of system time, and displays system uptime.
7.8.2 Unit Information
Set Location – a brief description of the physical location of the unit.
Set Contact – the name of the person who manages the unit.
7.8.3 Screen Saver
Sets the time-out before the screensaver starts.
Enable or disable Screen Lock as required. If enabled, enter the desired 4 digit Screen
Lock Code. This code will be requested in order to exit the screen saver.
There are two types of screensaver: Normal – in which the model, forward and reflected
power are shown meandering about the screen, and Stealth in which nothing is shown.
7.8.4 Users
Enter the Username for the remote login, used when accessing the unit via the web
remote.
Enter the Password for the remote login.
7.8.5 Ethernet
Enable or Disable DHCP as required. When DHCP is set to off, enter the static IP details:
1. Enter the static IP
2. Enter the subnet mask
3. Enter the gateway
4. Enter DNS 1
5. Enter DNS 2
6. Enter the ntp server IP (if used).
The MAC address of the unit is displayed here, and may be required for setting up
access to your network.
With DHCP set to on (dynamic IP), the system will take some time (usually a few seconds)
to gather the required IP configuration from the DHCP server.
To Next Page
Loading...
