7.8.14 Reboot
This parameter will reboot the unit.
7.8.15 Factory Reset
Performs a factory reset, setting all the parameters to its default value except for the
network settings. All user changes will be lost.
7.9 Web Remote
The V3 transmitter provides a graphical web based interface for ease of use and control.
This can be accessed by navigating to the IP address of the unit in any standard web
browser.
After entering the login details for the unit, the user can then read and write all
parameters and also perform firmware upgrades.
All parameters are saved and updated dynamically as they are changed in the remote.
The system serves a mobile-optimized version when accessed from a mobile web
browser.
7.9.1 Authentication
Browse to the IP of the unit (navigate to System > Ethernet. Refer to the Ethernet section
in this manual to set up Ethernet). You will be required to authenticate by entering the
password. This password must match the one selected in the System > Users > Password.
The default password is ‘pass’.
7.9.2 Web Remote Interface
The user interface is divided into several sections: Status Bar, Alarms and Notifications,
Navigation Bar and Transmitter Controls.
To Next Page
Loading...
