CONSTRUCTION & REENOVATION 29 2022/12 - Indice de révision : D - Code : 32570
9.5. Frost protection setpoint
Setting the frost protection set point temperature. When the measured water temperature falls below
the set point temperature, filtration is forced on to prevent freezing of the water.
9.6. Buffer tank
To be activated if a water level regulation panel or water level sensors are connected to the BWT Pearl
Connect panel.
If filtration is set to automatic mode, the filtration pump will stop in response to a low level warning and
start in response to a high level warning.
9.7. History
Pump power: used to configure the power of the filtration pump to calculate the operating cost.
Cost per kilowatt-hour: used to configure the cost of a kilowatt-hour according to your electricity
subscription.
Off-peak hours: used to set the off-peak hours as per your electricity subscription.
Warning messages: log of warning messages.
Delete warnings: deletes saved warning messages.
Delete log: deletes the log of temperature and electricity consumption.
9.8. Pairing
Associated devices: used to view and mange devices connected to the BWT Pearl Connect app.
Add a device: used to synchronise a BWT Pearl Connect panel to the app.
RED 2 electrical panel terminals
To Next Page