4-1 Charging/Discharging Instructions 97
The electric lock working mode can be set through "Multimedia" →“New
energy” → “Charging setting”
, and please refer to the working mode settings
of electric lock via the multimedia..
If the charging plug cannot be pulled out after unlocking, attempt to unlock for
several times. If the charging plug cannot be pulled out, try emergency
unlocking. For the operation steps, refer to the emergency unlocking of
charging port in section about the charging port electric lock control.
■ Disconnect the power supply plug.
■ Close the charging port plug cap
and vehicle charging port cap.
■ Put the charging equipment into
the special charging bag and
place it properly.
(Do not close the charging port cap when the charging port plug cap is fully
open.)
Do not let the 3-pin to 7-pin equipment fall from height. Do not move the
charging equipment by directly pulling the cable. Handle it gently and put it at
a cool and shaded place after use.
Single-phase AC charging through charging pile
1. Description of equipment
Single-phase AC charging box
■ The charging box can be used to charge the vehicle. For the use of charging
equipment, refer to its instruction manual or follow the instructions.
■ Specification of equipment: 220V AC 50Hz 32A
To Next Page
