BYD e2 - Wiper Switch

70
3-4 Switch
Wiper switch
■ The control lever is used to control the
windshield wiper and scrubber. The
lever is controlled with five gears:

：
High speed

：
Low speed

：
Intermittent

：
Stop

：
Jogging
■ To select a level, pull up or push down the control handle.
■ The wiper wipes continuously at low speed and high speed positions.
■ To run the wiper under one-time wiping mode “
”, push down the control handle
from “
” to run the wiper at low speed, till the control handle is released. (Upon
release, the wiper will complete the current cycle and stop at the initial position).
■ Under the intermittent mode “ ”,
rotate the intermittent knob on the
wiper switch to prolong the wiping
interval along the narrowing of the
rainfall indicator bar.
Front windscreen wiper and
washer
■
To clean the front windscreen, pull
backward (Towards the steering
wheel) the wiper control handle so that
the washer sprays washing fluid
continuously and meanwhile the wiper
runs.
■ Upon release of the control handle, the
washer stops the spraying of washing
fluid and the wiper continues to wipe
for 3 cycles and then stops.