Conditions for working of Auto Hold
■ The AVH is under ready status.
■ The vehicle is stopped completely by the brake pedal.
■ Depress the brake pedal deeply to activate the AVH. The working indicator lamp turns
green.
■ After the Auto Hold is working for 10min, the application of EPB is automatically
requested. After the application of EPB, the Auto Hold returns to ready status.
Note
● The AVH can be activated only when all conditions for activation of Auto Hold are
met.
● When the gearshift knob is shifted from "D" to “R”, the system enters the vehicle
movement condition. In such case, the AVH function will not be activated. The
system exits the vehicle movement condition after the AVH button is pressed or the
vehicle speed is >10km/h.
Driving essentials
■ Must lower the driving speed in the headwinds to control the car.
■ Must drive the car slowly and keep it at the correct angle on the side of the street. Do
not drive the car on objects with high and sharp edges or other road obstacles;
otherwise it may cause a serious damage to the tires.
■ Must lower the driving speed on bumpy roads. Otherwise the impact may cause serious
damage to the wheels.
■ When driving on wet roads, must avoid the road sections with excessive water.
■ The brakes will probably be wetted when the vehicle drives through deep water.
Carefully drive the vehicle and lightly depress the brake pedal to dry the brakes.
■ The power battery is located on the bottom of vehicle. Notice to guard the power battery
against collision during driving.
To Next Page
Loading...
