CAB a2+ - Firmware Update Error Messages; Clearing Service Counters

40 Configuration Instructions Edition 5/06
Test functions
A2+/A4+/A6+/A8+
The Status print contains the following information:
Tab. 17:Information in Status print
Symbol Information
• Device type
• Version and creation date of the firmware
• Version and creation date of the system loader (bootloader)
Current values of selected local settings (see "4.1.1" on Page 21).
Current values of selected device settings (see "4.1.2" on Page 22).
Current values of selected print parameters (see "4.1.3" on Page 23).
Current values of selected interface parameters (see "4.1.4" on Page 25).
Status of PIN activation (see "4.1.6" on Page 27).
• Operative time
• Number of labels printed
• Printed length with thermal transfer printing and thermal direct printing
• Current measured values of the printhead temperature and heat voltage
• Information on the working points of the label sensor
Line
pattern
The Status print presents lines differing in thickness at various distances at the end.
They are used to evaluate the print quality.