A2+/A4+/A6+/A8+
Test functions
Edition 5/06 Configuration Instructions 49
5.9.1 Event log
The label printer saves the following events in the Event log:
• Hardware fault
• Printhead replacement with a change in resolution
• Adjustment of the label sensor
• Firmware updates
• Resetting of the service counters
The printout of the Event log occurs using the heat level and print speed specified in the menu
Setup > Print param.
1. Insert service key into a USB master interface.
2. Insert printable medium (labels, endless paper) which extends across the entire printing width.
3. If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum
width.
4. Press the menu button.
5. Select Test > Event log menu.
6. Start printout with the ↵ button.
Fig. 22: Event log
The Event log contains the following information:
Tab. 20:Information in the Event log
Access only when service key is inserted!
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.
Location Description
First line Version number and creation date of the firmware
Second line Version number and creation date of the bootloader
Left column Date and time the event occurred
Right column Brief description of the event
To Next Page
Loading...
