To Next Page

To Previous Page

8.4 Writing

The storage devices can be written to in several ways. The most functionally secure way is writing to the storage

device via a data interface.

Attention!

The device selected as Default storage is written to by default. To write to another device specify the

path name of the device in the le name ( “Programming Manual“).

Example:

With direct programming, the command sequence for saving a label (le XYZ) has the following form:

Ms LBL; XYZ Command for saving the le XYZ

J |

H 100,0,T |

S l1;0,0,68,71,104 | Contents of the le XYZ

T 10,10,0,3,pt15;memory card |

A 1[NOPRINT] |

Ms LBL End of save command

• After transfer of the command sequence, the le XYZ is saved with the commands from J to A.

• Only one label is printed each time the le XYZ is called up.

• The [NOPRINT] parameter in command A suppresses the printing of a label when the le is saved.

• To print the label a variable number of times, use command A [?].

8.5 Storage Device Functions in the Ofine Menu

Accessing the Storage device menu is only possible if a storage device is installed and dened as Default

storage  "4.1.4" on page 15.

8.5.1 Load Label

Labels whose descriptions are saved on the storage device can be printed using the Load label function.

1. Start Ofine menu.

2. Select Storage device > Load label.

The content of the folder "labels" will be shown.

3. Select the desired label.

4. Conrm with OK.

If a label is selected which was saved with a xed contents and xed label quantity, the print job is started

immediately.

If additional input on the label description is required, the display requests to enter the variable data.

For label descriptions with a variable label quantity, a prompt to enter the label quantity is displayed.

Enter the label quantity/variable data.

5. Select OK to start the print job.

8 Storage Devices

CAB EOS1 Configuration Manual

Other manuals for CAB EOS1