Setup
12 ©2021 CAE 905K720652 v1.0
CAESimEquip
Portable Simulation Setup Steps
Setup steps are required for simulations that may use:
• Defibrillator
• AED or
• Transport Ventilator
Steps should be performed in the sequence provided in the Portable Simulation Setup table.
Accompanying details are in the following pages.
Step 1. Remove Equipment from Boxes
Tools required:
• Box Knife - suggested for opening cardboard boxes
WARNING: Be careful if using knives to open boxes, to prevent personal injury or damage to
equipment.
It may be beneficial to place equipment on a table during unpacking so that it is visible and available
during the setup process.
1. Check the battery power prior to running a simulation. The battery may require charging.
2. Place the router and router cable inside the Transport Bag.
3. Place the tablet inside the front sleeve of the Transport Bag. Place the tablet cables inside
the Transport Bag
4. All additional limbs, cables, and equipment may be placed inside the Transport Bag until
ready to use.
Portable Simulation Setup
1 Remove equipment from boxes.
2 Connect breathing circuit or medical cables.
3 Power on equipment.
4 Connect to WiFi:
• Using a Patient Simulator or
• Standalone - Setup the Router
5 Launch Maestro software.
6 Launch SimEquip software.
To Next Page
Loading...
