Setup
28 ©2021 CAE 905K720652 v1.0
CAESimEquip
Bedside Medical Cart Simulation Setup
Steps
Setup steps are required for simulations that may use:
• Ventilator or
• Anesthesia Machine
Steps should be performed in the sequence provided in the Bedside Simulation Setup table.
Accompanying details are in the following pages.
Bedside Simulation Setup
1 Remove equipment from cart and boxes.
2 Attach monitor(s) to cart.
3 Attach articulating arm.
4 Connect medical hoses and cables.
5 Power on equipment.
6 Connect to WiFi:
• Connect to the Patient Simulator WiFi or
• Standalone - Setup the Router
7 Launch CAE Maestro.
8 Launch CAE SimEquip software.
9 Launch CAE Patient Monitor (applicable for Anesthesia Machine only).
To Next Page
Loading...
