Setup
14 ©2021 CAE 905K720652 v1.0
CAESimEquip
3. Place the opposite end of the power cord into the battery pack. Place the battery pack
inside the middle section of the Transport bag. Zip the middle compartment closed.
4. When facing the front of the Transport Bag, open the right compartment on the bag.
5. Connect the 3-Lead ECG cable to the electrotherapy pads.
6. Pass the 3-lead ECG cables through the elastic port in the zippered compartment on the
right side of the transport bag.
7. Secure the 3-lead ECG cable by passing the connector end of the cable through the elastic
loop and inside the middle compartment of the Transport Bag.
8. Repeat the steps 3 and 4 for the SpO
2
Probe.
Defibrillator Assembled
To Next Page
Loading...
