Cafection Encore VENTI - Hot Water Tank Maintenance

ENCORE VENTI Rev. 3 2021-10
73
www.cafection.com 800-561-6162
SERVICE & INSTALLATION MANUAL for Cafection's Encore Venti
8.4 Hot Water Tank
8.4.1 Tank parts
Inspection: quarterly
Preventive maintenance: every 60,000
cycles
To avoid any issue related to mineral
deposits, Cafection recommends having
the water tank assembly delimed to
remove all scale in the unit. The heating
element, the temperature probe,
the water level and the heater safety
switches may also need to be replaced.
Use a scale remover product such
as Scale Kleen by Everpure. See the
manufacturer’s instructions for more
details.
The float, the heater switch and the
water level switch of the tank should
be replaced after 100,000 cycles.
1. Turn off the machine and remove
the back panel.
2. Unplug the tank lid’s connectors
(see section8.3, fig.1.1) and the
probe connector.
3. Completely drain water from the
tank (see section9.1).
4. Remove the tubes (valve and water
tank).
5. Unscrew the guard to be able to
remove the tank.
Heater safety switch Water level switch
Heating
element
Float
Probe
Tank guard
Preventive Maintenance