User's Guide — 39
The following specifies the entry ranges that the calculator
for numeric,
Thread Size TPI/Pitch
less than 100
less than 100
Metric
Note: Entries outside of the ranges mentioned above will result in an
Entry Error.
provided
isThread
Classification section).
INTErNal ThrEaD
* Thread Pitch is only displayed for Numeric and U.S. Thread Sizes.
** If the resulting hole size is greater than 2 Inches or 50 mm, the
actual hole size will be displayed instead of adjusting to the closest
Drill Size.
To Next Page
Loading...
