Calculated Industries ElectriCalc Pro User Manual

16 — electricalc
®
Pro
, ,

Number of Wires — Used to enter or calculate
the Number of Wires in a raceway and calculate
cross-sectional Wire Area.
♦ First Press
Enters Number of Wires or calculates
maximum Number of Wires in Conduit.
♦ Second Press
Shows total cross-sectional area for all
entered Wires.
♦ Third Press
Shows total cross-sectional area of all entered
Wires of the selected Wire Insulation.

Conduit Size — Used to nd Conduit Sizes
based on the total area of the entered Wire
Types and Wire Sizes (up to 15 at one time). If
the quantity and Insulation Type have not been
entered, the calculator will assume 2 THHN Wires
for Single-Phase or 3 THHN Wires for Three-
Phase calculations.
♦ First Press
Enters or calculates Conduit Size.
Note: If a Wire Size has not been entered or
calculated, or an invalid Conduit Size is entered, the
calculator will display nonE.
♦ Second Press
Shows Total Number of Wires in the Conduit
for calculated Conduit Size. Shows the Conduit
internal Area for an entered Conduit.
Note: Third through fth presses will only be
displayed for calculated Conduit Sizes.
(cont’d)

Calculated Industries ElectriCalc Pro Specifications

General

Type	Scientific
Cover	Yes
Form factor	Pocket
Control type	Buttons
Product color	Yellow
Digits	8 digits
Display type	LCD
Display tilting	No
Display size (HxV)	15.88 x 63.5 mm
Display number of lines	- lines
Display size (HxV) (imperial)	0.625 x 2.5 \
Storage media type	-
Battery type	CR2016
Power source	Battery
Battery voltage	3 V
Number of batteries supported	1

Weight and Dimensions

Depth	16 mm
Width	76 mm
Height	142 mm
Weight	127.5 g