Calculated Industries ElectriCalc Pro - Calculator Operations and Settings; Preference Settings Configuration

User's GUide — 17
♦ Third Press
Shows Fill Percentage for the calculated
Conduit Size as determined by NEC
Table 1, Chapter 9.
♦ Fourth Press
Shows the Total Wire Area for all entered Wires.
♦ Fifth Press
Shows Remaining Fill Area. This value may be
negative if all Wires are the same size due to
Note 7 in NEC Chapter 9, Table 1.

Conduit Type (Cond Type) — Used to select
the desired Conduit Type. Pressing these keys
with a value between 1 and 12 will select the
corresponding Conduit Type, as specied in the
list below (i.e.,    selects the EMT
Conduit). Continuous presses of   toggle
through the available Conduit Types.
♦ First Press
Displays the currently selected Conduit Type.
1) EMT
2) ENT
3) FMC
4) IMC
5) LFNB
6) LFNA
7) LFMC
8) RMC
9) P-80
10) P-40
11) P-A
12) P-EB