User Manual AMETEK Programmable Power
BPS Series 52
4.7.6 USB Interface
A standard USB Series B device connector is located on the rear panel for remote control. A standard
USB cable between the AC Source and a PC or USB Hub may be used.
Note: Use of the USB port to control more than one power source from a single PC is not
recommended, as communication may not be reliable. Use GPIB interface for multiple power
source control.
Figure 4-10: USB Connector pin orientation.
Pin Name Description
1 VBUS +5 VDC
2 D- Data -
3 D+ Data +
4 GND Ground
Table 4-10: USB Connector pin out.
To Next Page
Loading...