Calnex Sentinel - Page 27

Using Sentinel
CX3001 v7.0 © Calnex Solutions 27
calnexsol.com |
Auto-Negotiation
This allows auto-negotiation to be Enabled or Disabled
When Enabled , Sentinel auto-negotiates the line rate with the other device
When Disabled , the user must select the media type from the Ethernet Media
drop down menu
Ethernet Media
Select media type for when Auto-negotiation is Disabled . Choose from
100BASE-T , 1000BASE-T , 100BASE-FX and 1000BASE-FX 10G
VLAN 802.1Q
Turn On / Off VLAN Ethernet packets tagging according to 802.1Q specification
VLAN ID
VLAN identifier
VLAN Priority
VLAN priority setting, range 0 to 7
DHCP
Turn on/off using DHCP server for automatic IP allocation
IP Address
IP-address to assign for module if DHCP is Off , the address entered should be
in IPv4 or IPv6 format depending on the option chosen for PTP/NTP. Sentinel
NTP client on units with serial numbers below 400000 only supports IPv4
unicast mode. Selecting IPv6 will result in no measurement data being
recorded.
Mask
Network mask, IPv4 or IPv6 format
Gateway
IP-address of the gateway in the network; IPv4 or IPv6 format
The Ping button allows the user to ping the gateway address currently
specified
MAC Address
Read-only. Displays MAC Address of corresponding Packet module.