p. 17 - Manual FA01294-EN - 12/2018 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Close the gate.
Insert the magnetic closing limit switch fin on the rack.
The fin magnet must be at a distance between 10 and 30 mm from the magnetic sensor.
~ 20
Fasten the support to the rack using the headless screws supplied.
The limit switch magnet must be perpendicular to the magnetic sensor.
Fasten the limit switch fin using the screw (supplied).
To Next Page
Loading...
