~1°
~89°
+
-
~1°
~89°
+
-
p.
15 - Manual code:
FA01036-EN v.
- 01/2018 - © Came S.p.A. - The manual's contents may be edited at any time without notice.
To correct the horizontal position:
- raise the boom;
- turn the mechanical closing stop clockwise to increase the boom travel or counter clockwise to reduce it .
Fasten the stop with a counter nut .
Establishing the endstop points
Close the inspection hatch and power up the system. Activate the barrier to check whether the boom is parallel to the road surface when close
and at about 89° when open.
⚠
The boom's opening and closing maneuvers must be performed with the inspection hatch closed.
To correct the boom's vertical position:
- lower the boom;
- open the inspection hatch;
- turn the opening mechanical stop clockwise to increase the boom's travel or counter clockwise to reduce it .
Fasten the stop with a counter nut .
To Next Page
Loading...
Need help?
General
