To Next Page
T
Teresa HughesSep 10, 2025
Why does the PROGRAMMING LED stay lit on my CAME Gate Opener?
- MMarcus ShepherdSep 12, 2025
If the PROGRAMMING LED stays lit on your CAME Gate Opener, it could be due to using an NC control button instead of NO (2-7).
Why does the PROGRAMMING LED stay lit on my CAME Gate Opener?
If the PROGRAMMING LED stays lit on your CAME Gate Opener, it could be due to using an NC control button instead of NO (2-7).
Why does my CAME VER12 Gate Opener start too slowly?
If your CAME Gate Opener starts too slowly, eliminate all mechanical friction, check the door balancing and check the tautness of the belt/chain.
Why does my CAME Gate Opener invert travel direction at the limit switch?
If your CAME Gate Opener inverts the travel direction at the limit switch, check the proper direction of the door travel. Also, eliminate any mechanical friction and check the door balancing.
What to do if my CAME Gate Opener neither opens nor closes?
If your CAME Gate Opener isn't opening or closing, begin by checking the power supply and line fuses. Also, verify that the (1-2) NC safety contact is not open.
Why my CAME VER12 Gate Opener does not perform automatic closing?
If your CAME Gate Opener does not perform the automatic closing, check that the A.C.T. trimmer is not set to minimum and check the proper direction of the door travel.
Why is my CAME Gate Opener pushing weakly or inverting direction?
If your CAME Gate Opener is pushing too weakly or inverting the direction of travel, try adjusting the sensitivity. Also, eliminate any mechanical friction, check the door balancing, and check the tautness of the belt/chain.
Why does my CAME VER12 Gate Opener open but not close?
If your CAME Gate Opener opens but doesn't close, the issue might be with the N.C. safety contact (2-C1) being open. In this case, check the proper direction of the door travel. You should also check the balancing of the overhead garage-door.
Why is the photocell not working on my CAME Garage Door Opener?
If the photocell is not working on your CAME Garage Door Opener, it may be because The N.C. safety contact (2-C1) is open. Check proper functioning of the photocell.
What to do if my CAME Garage Door Opener closes but does not open?
If your CAME Garage Door Opener closes but does not open, check the balancing of the overhead garage-door.
Why is the automatic closing not working on my CAME Garage Door Opener?
If the automatic closing is not working on your CAME Garage Door Opener, check that the A.C.T. trimmer is not set to minimum and verify the proper direction of the door travel.
Checks and considerations before commencing the installation process.
Demarcating the site, handling heavy units, and correct command placement.
Ensuring EN 12453 compliance and verifying safety device functionality.
Explanation of DIP switch functions for various programming modes.
General| Brand | CAME |
|---|---|
| Model | VER12 |
| Category | Gate Opener |
| Language | English |
